Heavy-Feed Inserts – R4 12mm IC
| Insert Part Number | IC | Thickness | # of Usable Edges | Corner Radius (Actual) | Program Radius* (Bull Nose) |
DOC (Max.) | DOC (Recommended) | FPT** (Adjusted) |
|---|---|---|---|---|---|---|---|---|
| RF12-T | 12MM | .220" | 4 | .094" | .135" | .060" | .020-.050" | .025-.070" |
| RF12-D | 12MM | .220" | 4 | .094" | .135" | .060" | .020-.050" | .020-.055" |
| RF12-F | 12MM | .220" | 4 | .094" | .135" | .060" | .020-.050" | .035-.080" |
* A special corner radius value is required for correct programming of a high-feed insert. Using the program radius avoids gouging of the corners in the workpiece material.
**The FPT number here is already adjusted for chip thinning - use this number to calculate the IPM programmed into the machine program.
The high-feed insert will naturally leave a small amount of extra material at the bottom-most layer of the cut, at the intersection of the wall and pocket floor.
RHINO-FEED inserts are labeled with dots to indicate die position during pressing. For the most accurate runout when loaded into the cutter body, make sure each insert is loaded with the corresponding edge.
** Start with these filters – they will guide you to the right insert for your application **
| Item | Best For | Carbide | Edge Type | Coating | Grade | Price | Inventory | ||
|---|---|---|---|---|---|---|---|---|---|
|
64395 RF-12-T-DMP25-TS |
ISO | 2-Mid-hard (Shock & Wear) | Strong | 3-High-temp Si | DMP25-TS |
In Stock
Order multiples of 10 EA |
|
- ISO
- 2-Mid-hard (Shock & Wear)
- Strong
- 3-High-temp Si
- DMP25-TS
