Search in Category
Inserts
Filter Your Search
Carbide
Grade
Shop by Category
Loading...
Mini-Feed Inserts – R2 8mm IC
| Insert Part Number | IC | Thickness | # of Usable Edges | Corner Radius (Actual) | Program Radius* (Bull Nose) |
DOC (Max.) | DOC (Recommended) | FPT **(Adjusted) |
|---|---|---|---|---|---|---|---|---|
| RF08-D | 8MM | .125" | 3 | .062" | .088" | .030" | .010-.025" | .012-.032" |
* A special corner radius value is required for correct programming of a high-feed insert. Using the program radius avoids gouging of the corners in the workpiece material.
**The FPT number here is already adjusted for chip thinning - use this number to calculate the IPM programmed into the machine program.
The high-feed insert will naturally leave a small amount of extra material at the bottom-most layer of the cut, at the intersection of the wall and pocket floor.
RHINO-FEED inserts are labeled with dots to indicate die position during pressing. For the most accurate runout when loaded into the cutter body, make sure each insert is loaded with the corresponding edge.
Viewing Page 1 of 1
(3 results)
View:
| Item | Best For | Carbide | Coating | Grade | Price | Inventory | ||
|---|---|---|---|---|---|---|---|---|
|
62290 RF-08-D-DMP25-TCI |
ISO | 2-Mid-hard (Shock & Wear) | 4-Medium-temp | DMP25-TCl |
In Stock
Order multiples of 10 EA |
|
||
|
62190 RF-08-D-DMK30-TCI |
ISO | 1-Toughest (Shock Resistant) | 4-Medium-temp | DMK30-TCl |
In Stock
Order multiples of 10 EA |
|
||
|
62090 RF-08-D-DMK25-TCI |
ISO | 2-Mid-hard (Shock & Wear) | 4-Medium-temp | DMK25-TCl |
In Stock
Order multiples of 10 EA |
|
