SBN Finishing Series Spare Parts & Tools

 
SBN Spare Parts & Tools
Insert Screw Thread Wrenches TORX® Torque Nm/in.lbs. Miscellaneous
Description Catalog No.
SBNS-0500-T20 M5x.5 T20-T 6.0/53 Special Anti-Seize Grease
ASG-120
SBNS-0750-T20 M5x.5 T20-T 6.2/55
SBNS-1000-T20 M6x.75 T20-T 6.5/58

TORX® is a registered trademark of Camcar/Textron.

NOTE: New cutter bodies may require additional torque to fully seat the inserts. Once new cutter pockets are "broken in," the recommended torque specs in the chart can be followed regularly.

SBN Finishing Series Spare Parts & Tools

Correctly Applying Anti-Seize and Indexing Your SBN Insert

  1. Correctly Applying Anti-Seize and Indexing Your SBN InsertAnti-seize must be applied before using tool for first time.
  2. Remove screw from cutter body.
  3. Generously apply anti-seize to entire length of screw body, not to just the threads (see diagram).
  4. Clean out insert pocket before assembly of insert/screw combination.
  5. Place insert into cutter-body pocket. If you have already used one edge of your SBN insert, rotate insert 180° before placing into pocket.
  6. Place screw with applied anti-seize into position in cutter body.
  7. While gently pushing on the end of the TORX® screwdriver/wrench, begin tightening the screw (may turn with slight resistance in order to pull insert tight into the pocket).
  8. Tighten screw to snug fit, taking care not to overtighten. Follow torque specifications shown above.
  9. Repeat steps 2-8 for each insert change.
  10. Replace screw with each new box of inserts to assure maximum performance.